GB - 13
Hour Meter
Records total number of
hours the engine has
been run.
IMPORTANT: Keep a
record of Hour Meter
readings for
recommended Lubrication
and Maintenance
intervals.
NOTE: For accurate
readings be sure Ignition
Switch is OFF when unit
is not in operation.
FILLING FUEL TANK
Add fuel to Fuel Tank as needed. See your
Engine Manual for correct type and grade of
fuel.
To add fuel to the fuel tank:
1. Place unit in an open or well-ventilated
open area.
2. Stop the engine.
3. Clean the fuel cap and the area around
the fuel cap to prevent dirt from entering
the fuel tank. Remove the cap from the
fuel tank.
4. Fill the fuel tank to within 1 in. (25 mm)
below bottom of filler neck.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
PRE-START
1. Check Safety Interlock System
If this system does not function as described
do not operate until repairs are made.
2. Check Air Cleaner
Check air filter for dirt. Clean as required.
Follow Engine Manual Maintenance
Schedule.
3. Check Engine Fuel and Crankcase
Oil
Check and add fuel if required. Check that
engine crankcase oil is full. Follow Engine
Manual Maintenance Schedule.
4. Check Tire Pressure
5. Check Hydraulic Fluid Level
6. Adjust Seat
Be sure all controls can be reached safely
from operator’s position.
7. Set Cutting Height
Make sure the deck is set to the correct
cutting height.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
CAUTION: Make sure all
hardware is tight, all safety
devices are in place and all
adjustments are made correctly.
To Next Page
Loading...
