Why is the small seeds box not emptying evenly on my GREAT PLAINS Farm Equipment?
If the small seeds box is not emptying evenly on your GREAT PLAINS Farm Equipment, the adjustable divider might not be set evenly. Move the adjustable divider to create more volume in areas that run out first.
What to do for coulters and openers plugging in no-till conditions GREAT PLAINS Farm Equipment?
Drill at a slight angle to rows.
How to fix uneven seed spacing on GREAT PLAINS 605NT?
To address uneven seed spacing or stand with your GREAT PLAINS Farm Equipment, start by reducing field speed. Also, ensure that the feed cups and seed tubes are clean. Check the frame height and consider waiting for drier conditions to avoid ground drive wheel slippage. If the seed cups are too wide, adjust the drive type speed and close the feed cup flutes. Inspect the chain for slack and wear. If mud builds up on the Seed-Lok® wheel, lock it up or wait for drier conditions.
Why is the seed rate inaccurate on my GREAT PLAINS 605NT Farm Equipment?
If the actual seed rate differs from the desired rate on your GREAT PLAINS Farm Equipment, check the tire pressure and frame height. Clean out any seed treatment buildup in the feed cup. Also, verify the gearbox, sprocket, seed-rate handle, and seed door settings.
What causes chain fouling on GREAT PLAINS Farm Equipment?
Chain fouling on GREAT PLAINS Farm Equipment can be caused by debris in the retainer clip. Ensure that the retainer clip is facing opposite the direction of chain travel.
Why is the acremeter inaccurate on my GREAT PLAINS Farm Equipment?
An inaccurate acremeter on your GREAT PLAINS Farm Equipment can stem from several causes. Excessive wheel slippage is a primary factor, so check the frame height and consider waiting for drier conditions. Misaligned passes, leading to gaps or overlaps, can also affect accuracy. If wheel slippage varies consistently, develop a correction factor for your specific conditions.
Why is the actual seed rate different than desired on my GREAT PLAINS Farm Equipment?
If the actual seed rate differs from the desired rate on your GREAT PLAINS Farm Equipment, several factors could be responsible. Incorrect tire pressure or frame height may be the cause, so check both. A build-up of seed treatment in the feed cup can also affect the seed rate; make sure to clean it out. Also, check gearbox, sprocket, seed-rate handle and seed door settings.
What causes excessive seed cracking with GREAT PLAINS Farm Equipment?
Excessive seed cracking with GREAT PLAINS Farm Equipment can be attributed to a few reasons. Primarily, excessive field speed can cause this, so reducing your speed is advised. Additionally, if the feed cup flutes are not open enough, it can lead to cracking.
What causes feed cup sprockets to lock up on GREAT PLAINS Farm Equipment?
If the feed cup sprockets are locked up or the feed cup drive shaft is twisted on your GREAT PLAINS Farm Equipment, clean out any foreign matter lodged in one or more feed cup sprockets and use clean seed. Remove any dried liquid insecticide buildup inside the feed cups.
What causes coulters not going deep enough on GREAT PLAINS 605NT?
If the coulters on your GREAT PLAINS Farm Equipment are not going deep enough, adjust coulters. Add weight when all rows are affected. Reduce row down pressure to standard and set coulters to prepare furrow more aggressively.
General| Brand | GREAT PLAINS |
|---|---|
| Model | 605NT |
| Category | Farm Equipment |
| Language | English |
To Next Page
