4
NOTE
(1)Do not let the unit out of the designed application range; otherwise it would cause
the heat exchanging tube cracking, refrigerant leakage or even explosion.
(2)Do not let the cold/heat source directly act on the stored foods, plants, animals,
precision instruments, and curiosities, otherwise their quality would be degraded.
(3)Only circulating water with satisfactory water qualify are allowed for the unit, as
unsatisfactory water quality would shorten the service life of the unit or even
malfunctions.
(4)When the unit has been put into use for some time, check for security of the
installation foundation. Unstable foundation would lead to deformation or even
safety accident.
(5)Once the unit is started up, stop it at least 6 minutes later, otherwise it would shorten
the service life of the unit. Never deliberately start or stop the unit frequently.
(6)Under subzero climatic conditions, pay attention to freeze protection. When the unit
is out of use in short time, do not cut off the power supply, as freeze protection will
not act normally. When the unit is out of used in quite long time, add anti-freezing
agent to water or drain the water system, otherwise it would make the shell and
tube crack and then leak.
DANGER
(1)Do not use the fuse out of the normal range or replace it with the electric wire,
otherwise it would damage the unit or lead to fire hazards.
(2)Do not start or stop the unit directly by the power switch, as it would be likely to
cause electrocution or fire hazards.
(3)Do not change settings of safety devices; otherwise it would lead to fire hazards and
explosion.
(4)Do not operate the unit with wet hands.
(5)Do not clean the unit without cutting off the power supply, as it would lead to
electrocution or personal injury.
(6)Do not let children pull power lines or climb the unit to prevent of electrocution or
other dangers.
(7)Do not touch high-temperature parts of the compressor and refrigerant lines, as it
would lead to burns.
(8)Do not touch sharp edges and fins of the heat exchanger; otherwise it would lead to
personal injury.ć
(9)Do not touch any moving part; otherwise it would lead to accidental injury.
(10)Do not stand on the unit or replace objects on it.
(11)Do not bend pipeline and retrofit the unit, otherwise it would lead to refrigerant
leakage, explosion, fire hazards or personal injury.
A Series Inverter Modular Air-cooled Chiller (Heat Pump)
To Next Page
Loading...
Need help?
General
