Operating Procedures / Photos
Fig.7-45
Fig.7-44
Screw
Fig.7-43
Motor
(refer to Fig. 7-45)
(refer to Fig. 7-44)
(refer to Fig. 7-43)
Disassemble axial-flow vane
Loosen tighten nut by spanner to take off nuts,
spring washer, flat washer, and take off axial-flow
vane forcibly.
tighten nut
axial-flow vane
Disassemble Motor and Motor Support
Unscrew the 4 screws fixing the motor,and
remove the motor. Unscrew the two screws
fixing the motor support, and remove the motor
support .
screws
Disassemble 4-Way Valve
Screw off the holding nut of the 4-way valve coil
and remove the coil. Use wet cotton cloth to wrap
the 4-way valve, unsold the four soldering points
connecting the 4-way valve, and remove the
4-way valve.
4-way valve
soldering points
To Next Page
Loading...
