Gree ETAC - Page 6

GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 6
Changing Batteries and Notices
1. Craefully press the locking tap down to remove the battery cover.
2. Remove old batteries and dispose of properly.
3. Insert two new AAA 1.5V batteries into remote control. Verify polarity is
correct.
4. Re-attach battery cover on the remote control.
Note
●
When changing the batteries in the control remote, do not use the old or mix
old with new batteries. This will cause the unit not to operation correctly.
●
If the remote control will not be used for a long time, remove the batteries
to prevent damage from battery leakage.
●
The remote control will operate the unit from a distance of up to 25 ft. (7.6 m) as long
as there are no obstructions. This is one-way communication only (from remote
controller to unit.)
●
To reset the remote control, remove batteries for 30 seconds. Then reinsert batteries
and remote control will default to factory settings.
Fig.1
Fig.2
66161332
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs
without notice and without incurring obligations.