INSTALLATION GUIDE
ETAC IR REMOTE CONTROL SYSTEM
Introduction: These instructions cover the installation and operation of the ETAC IR Remote
Control System.
Contents:
Remote Control IR Receiver
WARNING
DISCONNECT ALL ELECTRICAL POWER TO UNIT BEFORE INSTALLING
ETAC IR REMOTE CONTROL SYSTEM. FAILURE TO DO SO MAY CAUSE
PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
Installation Procedure:
out at the bottom (1) and then lift up (2).
connector on the front face of the electrical control box.
GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 1
Step 2: Locate IR Receiver module mounting holes and electrical
Step 1: Remove front panel from ETAC unit by pulling front panel
To Next Page
Need help?
General
