Gree FP-204WM-D - Operation Range; Notices for Operation; Operating Guide

Floor Ceiling Tpye Fan Coil Unit
1
1 Operation Range
(1) The operation pressure of the unit is no more than 1.6MPa. The entering water temperature
for cooling shall be lower than 5°C, otherwise condensate would be caused on the unit. The
entering water temperature for heating shall be not more than 70°C (normally 60°C), otherwise
the cupper tube of the heat exchanger would be corroded.
(2) The ambient temperature range for cooling is 16-40°C and 10-35°C for heating. The relative
humidity is equal or less than 95%.
(3) It is a kind of comfort air conditioning unit, not applicable to be used under the locations with
special requirements on corrosive, inammable gas or heavy smog (like, kitchen), otherwise,
the unit would fail to run properly or its service life would be shortened.
2 Notices for operation
(1) This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
(2) Children should be supervised to ensure that they do not play with the appliance.
(3) If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualied person in order to avoid a hazard.
(4) An all-pole disconnection switch having a contact separation of at least 3mm in all poles should
be connected in xed wiring.
(5) The appliance shall be installed in accordance with national wiring regulations.
3 Operating Guide
Only professional personnel could clean or replace the lter.
Before cleaning lter, the power must be cut off and wait until fan motor stops.
●
Remove the air filter, clean it by a vacumm
cleaner or if it is very dirty,wash it soap water,
then wipe off unit it is completely dry before
reinstalltion.
●
Clean the air conditioner and the remote
control with dry cloth or a vacuum cleaner. If
damp cloth is used, remove moisture by using
cloth afterward.