Service Manual
Installation and Maintenance
54
reversion loop
ProcedureStep
axial ow blade
washer
nut
motor
10.Remove reversion loop sub-assy
11.Remove axial ow blade sub-assy
12.Remove outdoor motor
screw
Twist off the screws used for xing the
reversion loop with screwdriver, pull it
upward and then remove the reversion
loop sub-assy.
Twist off the nuts used for xing the axial
ow blade, take out the washer and then
remove the axial ow blade.
Twist off the screws used for xing the
motor and then remove the motor.
screw
To Next Page
Loading...
