41
Service Manual
Installation and Maintenance
spots weld
suction pipe
discharge pipe
ProcedureStep
nuts with washer
compressor
15.Remove suction pipe and discharge pipe
16.Remove compressor
17.Remove support assembly
18.Remove caster wheel
19.Remove facing-piece assembly
Remove suction pipe and discharge pipe
from the unsoldering place of compressor
(Note: Discharge the refrigerant rst
before unsoldering.).
Unscrew 3 foot nuts with washer xing
compressor by wrench to remove
compressor.
Pull the castor whee then remove it,
Remove the other three castor wheels by
the same method.
1. Remove duct
Unscrew 5 screws xing duct to remove
the duct.
Unscrew 4 screws xing support
assembly to remove support assembly.
screws
screws
caster wheels
To Next Page
Loading...
