U-Match Series Service Manual
93
Disassembly of evaporator
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum fin. If
the time for disassembly shall be long, put the copper tube under pressurized condition.
1. Disassembly of
fixing screws on the
side panels of
evaporator
Disassemble the fastening
screw connecting left and
right side panels on the
evaporator and the upper
cover plate. (As is shown in
the arrows direction in
Graph.)
2. Disassemble
fastening screws
connecting evaporator
valve seal-plate and
joint flange
Disassemble the fastening
screws on the valve
seal-plate and remove the
valve seal-plate.
Disassemble the fastening
screws on the evaporators
joint flange. (As is shown in
the graph, box represents
fastening screws on
seal-plates while circle the
fastening screws on joining
flange.
Remove the evaporator.
Removed evaporator is
shown in the graph.
Removal and Assembly of Fan Motor
1. Loosen the screws
fixing the water tray
Use screwdriver to loosen
the screws fixing the water
tray
To Next Page
Loading...
