Gree GKH30K3HI - Connection Pipe Installation

Cassette Type Air Conditioner Unit
14
Bottom
Drain cap
Drain pipe mounting hole
Chassis
Drain
connection
Fig. 4.9
4.3 Installation of the Connection Pipe
4.3.1 Flare Processing
(1). Cut the connection pipe with the pipe cutter and remove the burrs.
(2). Hold the pipe downward to prevent cuttings from entering the pipe.
(3). Remove the flare nuts at the stop valve of the outdoor unit and inside the
accessory bag of the indoor unit, then insert them to the connection pipe, after that,
flare the connection pipe with a flaring tool.
(4). Check if the flare part is spread evenly and there are no cracks (see Fig. 4.10).
d2
d1
d1
d2
90°±1°
Fig. 4.10
4.3.2 Bending Pipes
(1). The pipes are shaped by your hands. Be careful not to collapse them.
Extend the pipe by unwinding it
√
×
Fig. 4.11