Gree GKH42K3FI - Page 146

U-Match Series DC Inverter Service Manual
143
Disassembly of air deflecting plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts
during disassembly, especially the joints of the air deflecting plate.
Step
Illustration
Handling Instruction
Disassembly of
sub-assy of air
deflecting plate
●Remove the air
deflecting plates from
the air deflecting plate
support assembly, and
then remove both ends
from the air sweeping
motor. joint (As is
shown in the graph,
arrow represents the
support assembly and
circle the air sweeping
motor joint.)
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts
during disassembly.
Step
Illustration
Handling Instruction
Disassemble of
water-containing
plate modules
●Remove the
water-containing plate
modules.
Disassembly of evaporator components
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum
fin. If the time for disassembly shall be long, seal the copper tube.
Step
Illustration
Handling Instruction
Disassembly of
evaporator
components
●Unscrew the 6 screws
of evaporator, 3 screws
of water groove press
board and the 2 screws
of water board to
remove the evaporator.
Disassembly of fixing plate sub-assy for air sweeping fans
Remark: Make sure that the power supply is cut off before disassembling and protect all the
parts during disassembly.
Step
Illustration
Handling Instruction
Disassembly of
fixing plate sub-assy
for air sweeping
fans
●Remove the display
board, mounting
support and mounting
plate of swing motor in
turn.