USER NOTICES
◆
When the unit is operating, the total capacity of the indoor units should be no
more than the capacity of outdoor unit. Otherwise, it can cause the shortage of cooling
capacity (heating capacity) of each indoor unit.
◆
The power supply of the indoor unit must be the unied power supply. The indoor
unit cannot have the individual power switch, and the entire indoor unit can only be
controlled by one main power control. Disconnect the main power of all the indoor units
before cleaning.
◆
In order to start the unit successfully, the general power supply switch of the air-
conditioning units should be turned to the “ON” position for 8 hours before running.
◆
After each of indoor units received the stop running signal, the fan motor of the
indoor unit will use the surplus cool or surplus heat of the heat exchanger go on running
for 20-70 seconds, this is the preparation for the next time use and this is the normal
phenomenon.
◆
When the selected mode of the indoor unit conicts with the mode of outdoor
unit, after 5 seconds, the wired remote control will display the operation conict, the
indoor unit will stop running, then to unify the running modes of the indoor unit and
outdoor unit, the unit will get right. There is no conict in the COOL mode and DRY
mode, and the FAN mode will not conict with any other modes.
◆
The appliance shall not be installed in the laundry
◆
An all-pole disconnection switch having a contact separation of at least 3mm in
all poles should be connected in xed wiring
To Next Page
Loading...
Need help?
General
