21
© Copyright, GREE Canada, 2021 © Copyright, GREE Canada, 2021
1. In cooling or drying operation, the condensation water will be drained to the
chassis and spattered by water-striking motor. As the temperature of condenser
is high, most of the condensation water will be evaporated and drained to
outdoor. So usually, only a little condensation water will be accumulated inside
the chassis and you do not need to discharge the water frequently
.
2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8"
is displayed to remind user to discharge water:
• Move the unit to a suitable place for discharging water; do not tilt the unit and
keep it horizontal during moving;
• Take the drainage pipe from the clip and pull out the rubber plug on the
drainage pipe to discharge water;
• Put back the rubber plug onto drainage pipe
after finishing discharging water
and then fix the pipe on the clip;
• After full water protection is eliminated and the compressor has been stopped
for 3 minutes, the unit will resume operation.
To Next Page
Loading...
