26
© Copyright, GREE Canada, 2021
9. Close the window sash securely against the Window panel.
Sponge A
Outer window
Plastic window
Wooden window
Window bracket
Inner window
Rear connector (upper)
Rear connector (lower)
10. Cut the sponge A to a proper length and seal the gap between upper part of
inner window sash and outer window sash.
11. Fix the inner window with window bracket and screw, so that it can not slide
vertically.dow sash securely
against the Window panel.
1. Install rear clip: Aim the rear clip (upper) at the rear clip (lower), fix them toge
ther, firmly press the clasp into the groove.
2. Clamp joint B+C into the inner side of window frame along the direction of
arrow.
Installation in a sliding sash window
Clasp
INSTALLATION IN A SLIDING SASH WINDOW
To Next Page
Loading...
