20
drainage port
There are 2 ways to remove collected water:
Use the continuous drainage option from the bottom hole
1
Removing Collected Water
1. In Cool or Dry mode operating, the condensation water will be drained to the chassis.
To empty the chassis, please follow the instructions bellow.
■ Drainage way as follows.
2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is
displayed to remind user to discharge water,the unit will turned off about 2min latter,
and all buttons are invalid.
● Turn the unit off and unplug from the electrical outlet.
● Use a small pan or move the unit to a suitable place to drain the water.
● Remove the pre-installed drain cap from the unit.
● Drain the water into the small pan or a suitable place.
● Once draining is complete,re-install drain cap.
● Press ON/OFF button to restart the unit.
To Next Page
Loading...
