13
Removing Collected Water
2. Screw the drain connector to (included in the
package) the spout by turning clockwise.
3.Insert the drainage hose into drain connector.
ATTENTION:
Installation of Heat Discharge Pipe
correct
correct
Note of Installing heat discharge pipe
The length of the heat discharge pipe is less than
1m. It is recommended to use it with shortest length.
When installing,heat discharge pipe should be as
flat as possible. Don’t prolong the pipe or connect
it with other heat discharge pipe.
In order to improve cooling efficiency,the heat disch-
arge pipe should be as short as possible and flat
without curve to ensure smooth heat discharge.
When using continuous drainage option from the middle
hole, place portable on a level surface and make sure
garden hose is clear of any obstructions and is directed
d
ownward. Placing portable on an uneven surface or
improper hose installation may result in water filling up
the chassis and causing the unit to shut off. Empty water
in
the chassis if shut off occurs, then check portable lo-
cation and hose for proper setup.
To Next Page
Loading...
