Gree GRS-CQ6.0Pd/Na-K - Page 26

AIR-TO-WATER HEAT PUMP CONTROL
22
Table of user function parameter
Code Function description Detail Range
1
Setting temperature selection:
Selection for setting temperature as
room temperature or outflow water
temperature
0: leaving water
temperature
1: room temperature
0~1(default: 0)
2 Forced Operation
0: no Forced operation
1: Forced cooling
operation
2: Forced heating
operation
0~2(default: 0)
3
Celsius/Fahrenheit switching:
Display temperature in Celsius or
Fahrenheit
0:Celsius
1:Fahrenheit
0~1(default: 0)
4 Thermostat control isEnable/disable
0: disable
1: enable
0~1(default: 0)
5 Enable/disable of quick sanitary heating
0: disable
1: enable
0~1(default: 0)
6 Enable/disable of disinfection operation
0: disable
1: enable
0~1(default: 0)
7 Enable/disable of holiday mode
0: disable
1: enable
0~1(default: 0)
8
Setting priority when under cooling
demand and sanitary water heating
demand are required at the same time
0: priority to cooling
1: priority to water tank
heating
0~1(default: 0)
9
Setting priority when under heating
demand and sanitary water heating
demand are required at the same time
0: priority to heating
1: priority to water tank
heating
0~1(default: 0)
10
Setting status of back-up heater(indoor
unit)
1: use half capacity of
Back-up heater(3kW)
2: use full capacity of
Back-up heater(6kW)
1~2(default:１)
11
Setting start date of disinfection
operation
0: Sunday
1: Monday
2: Tuesday
3: Wednesday,
4: Thursday
5: Friday
6: Saturday
0~6(default: 6)
12
Setting start time in 24 hours of
disinfection operation
00-00：00
01-01：00
…
23-23:00
0~23(default:23)
13
Enable/disable of Metal Base
(pedestal)heater
0: disable
1: enable
0~1(default:1)
14 Tank sensor quantity
1: one
2: two
1~2(default:2)
15 Tank equipment
0: NOT Equipped
1: Equipped
0~1(default: 0)
16 Other thermal equipment
0: NOT Equipped
1: Equipped
0~1(default: 0)
17 FCU equipment
0: NOT Equipped
1: Equipped
0~1(default: 0)
18 Remote air temperature sensor
0: NOT Equipped
1: Equipped
0~1(default: 0)
19 Heating operation level
0: high temperature cycle
1: low temperature cycle
0~1(default:1)