Disassemble evaporator
Operation procedures/pictures
To screw off the tapping screws from the back
of rear case, which fix the rear plate, and push
up the clasp of rear case, and pull out the conn-
ection pipe.(As shown in Fig.8-10).
Fig.
Screws
Fig.
Screws
Fig.
Screws
To screw off 1pc screw which is in the left side
of evaporator, and 3pcs screw in the right side
of evaporator, press the lowleft of the evaporator,
and move it, and take out the side-board clasp
from the groove and take out the evaproator, ca-
refully, and pay attention to protect connection
pipe. (As shown in Fig.8-11 and Fig.8-12)
To Next Page
Loading...