GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
100
Removal of Condenser
Removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work Instruction
4. Break off the
connection pipes.
Heat up the welding
points of connection
pipes through gas
welding until the pipes
break off.
NOTE: When welding the
pipes, do not let the flame
burn the other
components. The welding
points of condenser are
steel and copper welding
points. Be sure to
maintain the welding
quality.
5. Take out the
condenser.
Loosen the securing
screws of condenser
support. Take off the plate
type heat exchanger and
the support as a whole.
To Next Page
Loading...
