GREE DC INVERTER HEAT PUMP CONDENSING UNIT SERVICE MANUAL
72
4.4.2.2 Replacement of compressor
Step 1: Preparation
(1) Prepare the components for replacement
When carrying the old and new compressors, do not place the compressors horizontally or upside down. The
angle of inclination should be within ±30°. Make sure the lubricant inside the compressors will not flow from the oil
balance mouth. The suction and exhaust openings of the compressors must be sealed. If a rubber seal is missing,
user adhesive tape to seal the opening. This is to prevent the compressor oil from contacting the air.
NOTICE:
Before replacement, make sure the nameplates and models of the compressors are identical.
so be careful not to be scalded.
To Next Page
Loading...
