GREE U-Match 5 SERIES UNIT SERVICE MANUAL
105
Disassembly of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
2. Loosen the securing screws at
the foot of compressor.
●Use a wrench to twist off the
screw nuts at the foot of
compressor.
3.Break off the pipes that
connecting to the compressor.
●Weld the pipes that are
connected to the compressor.
●Then remove the pipes.
Note: When welding the pipes, do
not let the flame burn the other
components.
4. Remove the compressor from
the chassis.
●Take out the compressor and
replace it.
Note: When replacing the
compressor, avoid touching the
nearby pipeline and components.
To Next Page
Loading...