Gree GUD71PHS1/A-S - Page 107

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
104
Removal of electronic expansion valve
Note: Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
6. Secure the electric box
and arrange the wires as
required.
 Put the electric box back in place and
tighten up the screws.
 Arrange the wires as original.
7. Check and install the
panels.
 Check whether each component and
connection wire is well connected.
 If everything is OK, install the upper, left
and right panels. Tighten up the screws.
Model: GUD100W1/NhA-S, GUD125W1/NhA-S, GUD140W1/NhA-S, GUD100W1/NhA-X,
GUD125W1/NhA-X, GUD140W1/NhA-X, GUD160W1/NhA-X
Removal of front panel
Note: Before removing the front panel, make sure power is cut off.
Step Picture Work instruction
1. Remove the upper cover
plate.
 Unscrew the screws of the
upper cover plate with a
screwdriver.