Gree GUD71PHS1/A-S - Page 109

GREE U-Match 6 SERIES UNIT SERVICE MANUAL
106
Removal of front panel
Note: Before removing the front panel, make sure power is cut off.
Step Picture Work instruction
6. Install the upper cover
plate.
 Tighten up the screws
around the upper cover
plate.
Model: GUD100W1/NhA-S,GUD125W1/NhA-S
Removal of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels and
wires.
 Remove the upper, lower
and front panels.
 Loosen the securing
screws of the wires with a
screwdriver.
 Remove the wires.
Note: When removing the
wires, mark the wire
terminals corresponding to
their color so as to avoid
misconnection.
2. Loosen the securing
screws at the foot of
compressor.
 Use a wrench to twist off
the screws at the foot of
compressor.