GREE U-Match 5 SERIES UNIT SERVICE MANUAL
102
Removal of electronic expansion valve
Note: Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
7. Check and open the upper and
front panels.
●Check whether each component
and connection wire is well
connected.
●If everything is OK, install the
upper, left and right panels.
Tighten up the screws.
Note: Before removing the front panel, make sure power is cut off.
1. Remove the upper cover plate.
●Unscrew the screws of the
upper cover plate with a
screwdriver.
2. Remove the front grill.
●Unscrew the screws of the front
grill with a screwdriver.
To Next Page
Loading...
