How to get rid of the unusual smell from my Gree GWC18KG-K3DNA5A Air Conditioner?
If there's an unusual smell coming from your Gree Air Conditioner after starting it, it might be due to accumulated smells. Start by cleaning the filter. If the problem persists, the air conditioner itself may need cleaning. Please contact an authorized maintenance center for this.
Why does my Gree Air Conditioner emit mist in COOL mode?
If your Gree Air Conditioner emits mist from the air outlet vent in COOL mode, it's likely due to high indoor temperature and humidity. This mist should disappear once the indoor temperature and humidity decrease after the unit runs for a while.
Why is my Gree GWC18KG-K3DNA5A indoor unit not blowing air?
In HEAT mode, the unit will stop delivering air to prevent cool air when the indoor heat exchanger temperature is very low. Also, in HEAT mode, if the outdoor temperature is low or humidity is high, frost may form on the outdoor heat exchanger, causing the unit to automatically defrost. In dehumidifying mode, the indoor fan may stop to prevent condensed water from vaporizing again and to restrain temperature rising.
Why does my Gree GWC18KG-K3DNA5A not start immediately after restarting?
Your Gree Air Conditioner will not operate for approximately 3 minutes after being stopped. This is to protect the unit.
General| Type | Split System |
|---|---|
| Capacity | 1.5 Ton |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Noise Level (Outdoor) | 50 dB |
| Energy Efficiency Class | A++ |
| BTU Rating | 18000 BTU |
Details functionality of primary remote control buttons like ON/OFF, MODE, FAN, TIMER, and SWING.
Using the manual switch for operation when the remote is unavailable.
Procedure and frequency for cleaning the air filters.
Troubleshooting for unit not running, poor efficiency, and remote control issues.
Situations requiring immediate shutdown and dealer contact due to safety concerns.
Important notices regarding qualified personnel and authorized centers.
Guidelines for safe electrical connections, wiring, and circuit protection.
Requirements for selecting optimal locations for indoor and outdoor units.
Detailed instructions and precautions for proper grounding of the unit.
Steps for securely mounting the indoor unit's rear panel horizontally.
Procedures for connecting indoor and outdoor unit electrical wires.
Procedure for evacuating air and testing for refrigerant leaks.
To Next Page
