110
Installation and Maintenance
Service Manual
9.Remove isolation sheet
motor support
isolation sheet
ProcedureSteps
10.Remove 4-way valve
Twist off the tapping screws fixing the motor support,
pull it upwards and then remove the motor support.
Twist off the screws connecting isolation sheet and
end plate of condenser and chassis, and then remove
the isolation sheet.
Unsolder the pipe line between compressor,
condenser, gas and liquid valve, and then remove the
4-way valve. (note: release all refrigerant before
unsoldering).
4-way valve
2
To Next Page
Loading...
