9
+
Operation of wireless remote controller
SLEEP BUTTON
(3) Under the initial presetting temperature 69 F～81 F, after Sleep
function started up, the temperature will decrease
in every hour
,
after decreased, this temperature will be maintained.
(4) Under the initial presetting temperature , after
Sleep function started up, the temperature will decrease
in
every hour, after
decreased, this temperature will be maintained.
Sleep 3- the sleep curve setting under Sleep mode by DIY:
(1) Under Sleep 3 mode, press "Turbo" button for a long time, remote
control enters into user individuation sleep setting status, at this
time, the time of
remote control will display "1hour ", the setting
(2) Adjust " " and " " button, could change the corresponding
setting temperature, after adjusted, press "Trubo "button for
confirmation;
(3) At this time, 1hour will be automatically increased at the timer
postion on the remote control, (that are "2 hours" or "3 hours"
(4) Repeat the above step (2) ～ (3) operation, until 8hours
temperature setting finished, sleep curve setting finished, at this
time, the remote control will resume the original timer display;
temperature "88" will display the corresponding temperature of last
setting sleep curve and blink (The first entering will display
according to the initial
curve se
tting value of original factory);
or " 8 hours "), the place of setting temperature "88" will
display the corresponding temperature of last setting sleep curve
and blink;
temperature display will resume to original setting temperature.
●
●
Sleep3 - the sleep curve setting under Sleep mode by DIY could
be inquired:
The user could accord to sleep curve setting method to inquire
the presetting sleep curve, enter into user individuation sleep
setting status, but do not change the temperature, press "Turbo"
button directly for confirmation.
Note: In the above presetting or enquiry procedure, if continuously
within10s, there is no button pressed, the sleep curve setting
status will be automatically quit and resume to display the original
displaying. In the presetting or enquiry procedure, press "ON/OFF"
button, " Mode " button, " Timer " button or " Sleep " button, the sleep
curve setting or
enquiry status will quit similarly.
SLEEP
-
Name and function of wireless remote controller
82 F～86 F
1 F ～2 F
1 F ～2 F
1 F ～2 F
5 F ～6 F
To Next Page
Loading...
