Remote controller
buttons of this control which are not available to this unit will not be described below.
This wireless remote control is universal, and it could be used for many units, some
Operation of wireless remote controller
● One press this key to enter into TIMER
OFF setup, in which case the TIMER OFF
icon will blink. The method of setting is
the sameas for TIMER ON.
TIMER OFF
TIMER OFF button
7
SWING LEFT AND RIGHT BUTTON
●
Press this button to set swing angle,
which circularly changes as below :
OFF
This remote controller is universal. If it
rece ives threes kinds of following stat us,
the swing angl e will remain o riginal.
If guide louver is st opped when i t is
swinging up
and down, it will remian its
prese nt position.
indicates guide louver swings back and
fort h
in the five places, as shown in the
figu re.
SWING UP AND DOWN BUTTON
●
Press this button to set left & right swing angle
cycling as below:
OFF
TIMER ON
TIMER ON BUTTON
●
I FEEL BUTTON
●
●
Press this button once, to turn on the
I FEEL function , then the figure of "I FEEL"
will be displayed, after every press of
I FEEL
other function button, every 200ms to send
I FEEL once, after this function started,
the remote control will send temperature
to the main un it in every 10 minutes.When
repress this button, this function will be
turned off.
Timer On sett ing : Sign al “ON” will blink
and display, signal will conceal, the
nu mer ical sect ion will b ecome the timer
on sett ing stat us. During 5 sec onds blink,
by press ing ＋ or － button to adju st the
time valu e of nu mer ical sect ion, every
press of that bu tt on, the value will be
in creased o r decre
ase d 1 minu te. Hold
press ing ＋ or －bu tt on, 2 seconds later,
it qui ck ly change, the way of change is:
During the ini tial 2.5 sec ond s, ten numbers
change in the one pl ace of minu te, then
the one place is con sta nt, ten numbers
change in the tens pl ace of minu te at 2.5
sec onds speed and carry . During 5s blink,
press the Timer bu tt on, the timer sett in g
succee ds. The Timer On has been set up ,
repress the timer butt on, the Timer On
will be canceled. Bef ore sett ing the
Timer , please adjust th
e Clock to the
curre nt act ual time.
HEALTHY AND SCAVENGING BUTTON
Press this button to ach ieve the on and
off of healthy and scavenging functions in
operation status. Press this button for the
first time to start scavenging f unct ion;
LCD displays“ ”. Press the button for the
seco nd time to start healthy and scav enging
functions simultaneously; LCD displays“ ”
and “ ” .
Press this button for the third
time to
simultaneously. Press the button for the
fourth t ime to start healthy function; LCD
display “ ” . Press this button again to
repeat
quit h ealthy and scavenging functions
the operation above.
/
Name and function of wireless remote controller
To Next Page
Loading...
