EasyManua.ls Logo

Gree GWH12AVCXD-K6DNA1A/I - UV-C Lamp Function Instruction

Gree GWH12AVCXD-K6DNA1A/I
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
UV-C lamp function instruction
WARNING
This appliance contains a UV emitter. Do not stare
at the light source.
Unintended use of the appliance or damage to
the housing may result in the escape of danger-
ous UV-C radiation. UV-C radiation may, even
in small doses, cause harm to the eyes and
skin.
Appliances that are obviously damaged must
not be operated.
Before opening doors and access panels bear-
ing the ultraviolet radiation hazard Symbol for
the conducting user maintenance, it is recom-
mended to disconnect the power.
UV-C barriers bearing the ultraviolet radiation
hazard symbol should not be removed.
Do not operate UV-C lamps outside of the appli-
ance.
The method, frequency of cleaning, and neces-
sary precautions to be taken:
Prior to cleaning or other maintenance, the
appliance must be disconnected from the
supply mains.
Open the panel to take out the filter.
Use a soft cotton cloth to wipe the quartz
glass until it’s clean.
Reinstall the filter when it has been cleaned
and then close the panel cover.
This appliance contains a UV-C lamp.
Read the maintenance instructions before open-
ing the appliance.
Details for cleaning and other user maintenance
of the appliance:
Cleaning method: wipe the quartz glass with
soft cloth until the surface is clean.
Cleaning frequency: clean it every 6 months; the
cleaning frequency can be properly adjusted
according to the degree of air cleanliness.
Preventive measures:
The unit must be turned off and the power
must be cut off before cleaning. Otherwise, it
may cause electric shock and damage by UV.
Do not use volatile oil, alcohol, diluents or
lacquer to clean the UV-C lamp. Otherwise,
the UV-C lamp may be damaged.
Do not touch the fins of indoor unit to prevent
scalding.
Do not scratch the surface of glass when
wiping it.
WARNING
To avoid any dangerous situations, the user
shall not replace the UV-C lamp, which must be
performed by the manufacturer or the profes-
sionals of the maintenance or similar depart-
ment.
Do not operate the UV-C emitter when it is
removed from the appliance.

Related product manuals