121
7. Remove fan blade
Remove the bot holding the fan blade on motor sha , then re-
move gasket and washer.
8. Remove right side panel
Remove the screws holding the right side panel and valve support
9. Remove electrical box assembly
Remove the screws holding the electrical box assembly and
isolation board, loosen the bonding connection, then remove the
wiring terminal, li o box assembly.
10. Remove electric reactor
Remove the screws holding the reactor to remove
11. Remove fan motor and support
Remove the 4 screws holding the motor, remove wire connector,
then remove the two screws holding the motor support bracket
12. Remove mid-isolation board
Remove the screws connecting the mid-isolation board and con-
denser assembly
Fan Blade
Panel
Box Cover
Electrical
box assy.
Reactor
Support
Fan Motor
Isolation Board
Disassembly of Outdoor Unit, continued
9,000 & 12,000 btuh Warning - Wait 10 minutes a er power is disconnected before starting disassembly.
To Next Page
Loading...