Removal Procedure
clamp nut
axial flow blade
motor support
tapping screw
motor
weld spot
four-way
valve
4. axial flow blade
5. motor and motor support
6. four-way valve
Loosen the clamp nut with spanner, take out nuts,
spring washer, plain washer and then remove the
axial flow blade forcibly.
Twist off the fixing screws and then take out the motor.
Twist oft the screws used for fixing the motor support,
pull it upward and then remove the motor support.
Unsolder the spot weld between four-way valve and
other pipes and then remove the four-way valve
sub-assy.
Remove
Remove
Remove
62
To Next Page
Loading...
