Removal Procedure
1. top cover, front side panel
2. grille and right side plate
3. electric box
Twist off the clamping screws used for fixing the handle
with screwdriver, pull it downward forcibly and then
remove the handle.
Twist off the screws around the top cover, pull it
upward and then remove the top cover.
Twist off the screws around the front side panel and
then remove the front side plate.
Twist off the screws around the grille and then remove
the grille.
Twist off the screws between right side plate and end
plate of condenser, valve support, pull it upward and
then remove the right side plate.
Twist off the screws on electric box cover, pull out the
temperature sensor and then remove the electric box.
top cover
screw
handle
screw
grille
temperature
sensor
10.3 Removal Procedure of Outdoor Unit (24K Unit)
Ensure don not contact control panel when removing
electric box cover, if not, electrolytic capacity will discharge
and lead electric shock or burn out control panel.
Remove
Remove
Remove
61
To Next Page
Loading...
