110
Installation and Maintenance
Service Manual
Step Procedure
3. Remove display and panel
Screws that are locking the display board. Separate
the display board from the front panel.
Open the front panel; separate the panel rotation
shaft from the groove fixing the front panel and
then removes the front panel.
4. Remove detecting plate and electric box cover 2
Remove the screws fixing detecting plate and
remove detecting plate.
Remove the screws xing electric box cover 2 and
remove electric box 2.
5. Remove front case sub-assy
Remove the screws fixing front case. Loosen the
clasps of front case Life the front case sub-assy
upwards to remove it.
Panel
Panel rotation
Groove
Screw
Screws
Clasps
Front case sub-assy
Electric box cover 2
Display
To Next Page
Loading...
