125
Installation and Maintenance
Service Manual
Step Procedure
Remove connection screws connecting
the right side plate with the valve support
and the electric box. Then remove the
right side plate.
7. Remove right side plate
Remove the nut and gasket on the blade
and then remove the axial ow.
Remove the tapping screws xing the
motor and disconnect the leading wire
insert of the motor. Then remove the
motor.
Remove the tapping screws xing the
motor support and lift the motor support to
remove it.
9. Remove motor and motor support
8. Remove the nut and gasket and axial ow
axial flow
gasket
motor support
To Next Page
Loading...