86
Test Operation, Troubleshooting and Maintenance
(2) LSQWRF60VM/NaA-M, LSQWRF65VM/NaA-M and LSQWRF60VM/NhA-M
Replacement of the compressor
Note: be sure there is no refrigerant inside the system and power supply has been cut off before
replacement.
Steps Image Instructions
1. Remove the
front panels.
• Remove screws at the front panel.
• Loosened screws should be put
together to avoid loss.
• Pull the front panel upwards and
then remove it.
• Properly keep the removed front
panel to avoid from being damaged.
• Note: there are two clasps at each
panel for connecting with side
panels.
2. Remove power
lines and the
electric heater.
• Remove the insulation of the
compressor.
• Loosen screws of power lines with a
screwdriver.
• Draw out power lines.
• Draw out the electric heater.
• Note: power lines and their
terminals should be numbered to
avoid incorrect rewiring.
3. Disconnect
power lines to the
ompressor.
• Desolder pipes quick to avoid
deformation.
• Keep the replaced compressor
complete for further analysis.
4. Loosen screws
at feet of the
compressor.
• Loosen screws at feet of the
compressor with a adjustable or box
spanner.
• Loosened screws should be put
together to avoid loss.
To Next Page
Loading...
