91
Test Operation, Troubleshooting and Maintenance
Replacement of the compressor
Note: be sure there is no refrigerant inside the system and power supply has been cut off before
replacement.
Steps Image Instructions
1. Remove the front
panels.
• Remove screws at the front panel.
• Loosened screws should be put
together to avoid loss.
• Pull the front panel upwards and
then remove it.
• Properly keep the removed front
panel to avoid from being damaged.
2. Remove power
lines and the
electric heater.
• Loosen screws of power lines with a
screwdriver.
• Draw out power lines.
• Draw out the electric heater.
• Note that power lines and their
terminals should be numbered to
avoid incorrect rewiring.
3. Disconnect
power lines to the
compressor.
• Desolder pipes quick to avoid
deformation.
• Keep the replaced compressor
complete for further analysis.
To Next Page
Loading...
