GMV5 HR Heat Recovery Cooling and Heating Mode Exchanger
28
Fig. 5.4
4) Fix the power cord with wire-fixing clamp.
5) Take off the cable cross loop that is attached to the mode exchanger, as shown in Fig.5.5~5.8.
Replace with a local cable cross bushing.
One-to-one Cooling and Heating Mode Exchanger
Fig.5.5
One-to-two Cooling and Heating Mode Exchanger
Fig.5.6
One-to-four Cooling and Heating Mode Exchanger
Fig.5.7
To Next Page
Loading...
