GMV5 HR Heat Recovery Cooling and Heating Mode Exchanger
27
5.2 Connect Power Cord
NOTICE
！
The mode exchanger in the same system must be supplied power uniformly.
Fig. 5.3
Remark: The maximum quantity “n” of indoor unit is decided by the capacity of indoor unit, please
refer to capacity of unit.
(1) Use single-phase power air conditioner
1) Remove electric box cover of indoor unit.
2) Pass the power cord through rubber ring.
3) Connect power cord to
“
L1
，
L2
”
terminal and earthing screw. Please use the green bonding
screw to connect the earthing cord.The location is showing in the Fig 5.4
To Next Page
Loading...
