OPERATION OF WIRELESS REMOTE CONTROLLER
TURBO MODE
The desired setpoint, either in heating or cooling, can be achieved
faster if TURBO mode is used. After selecting the“HEAT” or
“COOL” mode button, push the “TURBO” button. The TURBO
icon will be displayed on the remote controller and the unit
will run at ultra high speed fan. To deactivate the feature, push the
“TURBO” button again. The unit will return to normal operation.
DISPLAYING SETPOINT OR INDOOR TEMPERATURE
ON FRONT PANEL:
The setpoint temperature or room temperature can be displayed on
the front panel. Only setpoint temperature is displayed on the remote
controller.
When the “TEMP” button is pushed once, the temperature
indicator is displayed. This indicates that the setpoint temperature
is displayed on the front panel.
When the “TEMP” button is pushed a second time, the display will
show an icon with a thermometer inside a house. This indicates
that the room temperature is displayed on the front panel.
The room temperature will be displayed for only 5 seconds before
reverting back to displaying room setpoint.
NOTE:
Only room setpoint temperature will be displayed on
the remote controller.
Room Temperature Display
WIFI BUTTON
Press and hold both the"Mode" and"Turbo" buttons for 10 seconds
until the unit beeps for the second time and the WIFI icon appears
on the display. Repeat the procedure to turn WIFI mode OFF.
See“Operation of Smart Control” section for more information.
WIFI Display
Turbo Mode Display
13
To Next Page
Loading...
Need help?
General
