Quiet Mode Display
OPERATION OF WIRELESS REMOTE CONTROLLER
QUIET MODE
Sapphire’s QUIET MODE function delivers quiet comfort to your
room. Press QUIET button to activate QUIET MODE in heating
or cooling mode. The QUIET icon will be displayed on
the remote controller. The unit operates normally for ten (10)
minutes or until room setpoint temperature is reached. Then
the Sapphire system will operate quietly at Low fan speed.
Press QUIET button again to cancel QUIET MODE.
NOTE: QUIET MODE cannot be selected in DRY or FAN
ONLY modes.
ENERGY SAVING MODE
The Sapphire System will not only keep you comfortable, they
will also save you money over the long run. Energy Saving
mode will automatically select the optimal fan speed to save
energy in COOL mode. The fan will automatically slow down
the closer the room temperature is to the setpoint. Press TEMP
and CLOCK simultaneously to activate Energy Saving mode.
The remote controller will display “SE”. Press TEMP and
CLOCK simultaneously to cancel Energy Saving Mode.
Energy Saving Display
FREEZE GUARD
In Heat mode, press"TEMP"and "CLOCK" buttons simultaneously
to start up 46°F heating function. When this function is started up,
“46°F" will be displayed on the remote controller, and the unit
will maintain room temperature above 46°F. Press"TEMP" and
"CLOCK" buttons simultaneously again to cancel Freeze
Guard protection.
Freeze Guard Display
14
To Next Page
Loading...
Need help?
General
