What to do if GREEN INSTRUMENTS Measuring Instruments show flow alarm but operating pressure is high?
If you're experiencing a flow alarm with high operating pressure, it could be due to a blocked flow path or air in the system. Here’s what you can do: * Clean the strainer. * Open any blocked valves. * Check that all hoses are intact. * Check and adjust the flow regulating valve. * Evacuate air by disconnecting the relevant hoses.
What to do if GREEN INSTRUMENTS Maritime G6200 have a blocked valve?
If you suspect a blocked valve, especially pressure holding, pressure reduction, or relief valves, inspect and clean them as needed. Also, check the condition of the impeller and end cover. If the impeller is swollen, consider using an impeller made of a different material.
Why is there low flow in GREEN INSTRUMENTS Maritime G6200?
Low flow can be caused by blockages in the system. You should check the system for blockages, paying special attention to disassembling and cleaning the non-return valve.
How to troubleshoot pump failure in GREEN INSTRUMENTS Maritime G6200 Measuring Instruments?
If the pump fails, first check the automatic fuse. If the fuse is fine, remove the end cover to see if the impeller is rotating. If it is not, this indicates a pump issue.
General| Operating Temperature | -20°C to +50°C |
|---|---|
| Power Supply | 24 V DC |
| Protection Class | IP65 |
| Material | Stainless Steel |
| Response Time | <15 seconds (T90) |
| Output Signal | 4-20 mA |
| Accuracy | ±2% of full scale |
To Next Page
