2322
Electric Automotive Compressor 12V Kit with inverter/Command/Cable Module - DS105138
Electric Automotive Compressor 24V Kit with inverter/Command/Cable Module - DS105181
Electric Automotive Compressor 12V Kit with inverter/Command/Cable Module - DS105138
Electric Automotive Compressor 24V Kit with inverter/Command/Cable Module - DS105181
• Do not use inappropriate oil, it may cause failures at the
system startup, as well as a short at the compressor´s electric
components may occur;
• The use of UV Dye may cause damage at the isolating
components of compressor oil. Therefore, it is prohibited to
mix gas with UV Dye at electrical systems;
• The recycling machine used by most workshops is not
recommended for the installation or maintenance of electri-
cal systems;
• Electric compressors are hermetically sealed to avoid leakage.
That means, there is less risk of refrigerant fluid leaking
compared to when they are mechanically sealed. However,
maintenance on a regular basis is necessary;
• Check the vehicle´s battery and alternator regularly, as it
might need replacement more often due to the generated
consumption of the electrical A/C, 24V models is of 30-40 A/h
and of the 12V is of 35-60 A/h.
Note:
- Battery should provide the necessary current and voltage;
- Connect battery, only, after all components of the
compressor, are installed at the vehicle;
- Check if battery poles are not inverted before installation,
it may burn the inverter;
- Do not use filament lamps to test the Rooftop system´s
electric circuit, it may burn the inverter – connector 5V);
- Do not use voltage higher to 5V for the compressor´s
connector/inverter
ERRO
16.0
o
C
PROBLEMA NO SENSOR INTERNO DE TEMPERATURA
AC AUTOMATICO
x
16.0
o
C
MOTOR DO EVAPORADOR EM CURTO
CV1 AC AUTOMATIC
x
16.0
o
C
AC AUTOMATICO
x
16.0
o
C
BAIXA TENSÃO
BATERIA BAIXA
AC AUTOMATICO
x
16.0
o
C
ALTA TENSÃO
BATERIA ALTA
• This device Warranty covers for any material defects, in case of
correct handling procedure has been carried out, for a period
of 3 (three) months from the date of acquisition, as well as this
Warranty foresees for any repairs and/or for a Unit replacement,
in case of defect;
• Any damage or malfunction caused by negligence, abuse,
non-conformity to the Manual Usage Instructions and/or for
any changes made at the product, shall not be covered by this
Warranty;
• No warranty shall be given for defects or damages caused by
unauthorized Services.
6.
WARNINGS
7.
SERVICE AND
WARRANTY
To Next Page