Greenlee Tools, Inc.
3
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
713 Plumbers Stud Punch
Operation
1. Hold the C-head handle securely. Push the slotted
handle forward, using the slot to extend the handle.
2. Spread the handles apart to lift the punch and clear
the opening in the C-head.
3. Position the punch on the metal stud.
4. Pull the slotted handle back, using the slot.
5. When the handle reaches the end of the slot and
the punch shaft and link are at their closest position,
punch the hole.
6. Push the slotted handle forward using the slot to
raise the punch in the C-head to clear and remove
the tool from the stud.
Note: This tool will punch to its rated capacity with
approximately 200 newtons (45 pounds) of handle
force. If excessive force is required, stop and inspect
the tool and the material.
Maintenance
Lubricate all moving parts with a lightweight oil or
Molykote
®
lubricant.
Description
The Greenlee 713 Plumbers Stud Punch is intended to
punch round holes in 20 gauge steel studs.
The 713 punches a 66.9 mm (2-5/8") diameter hole to
accommodate a 2" inside diameter PVC white or CPVC
gray schedule 40 pipe.
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any decals on the tool provide information for
avoiding hazards and unsafe practices related to the
use of this tool. Observe all of the safety information
provided.
Purpose
This instruction manual is intended to familiarize opera-
tors and maintenance personnel with the safe operation
and maintenance procedures for the Greenlee 713
Plumbers Stud Punch. This manual should be kept
available to all operating and maintenance personnel.
Molykote is a registered trademark of Dow Corning
Corporation.
To Next Page
Loading...
Need help?
General
