4
Important Safety Information
Electric shock and fire hazard:
Do not expose this unit to rain or moisture.•
Do not use the unit if it is wet or damaged.•
Use test leads or accessories that are appropriate for the application. Refer to the category •
and voltage rating of the test lead or accessory.
Inspect the test leads or accessory before use. They must be clean and dry, and the •
insulation must be in good condition.
Use this unit for the manufacturer’s intended purpose only, as described in this manual. Any •
other use can impair the protection provided by the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
The transmitter Live Line indication does not function if the batteries are dead or removed. •
Test on a known live circuit before use.
Do not apply more than the rated voltage between any two input terminals, or between any •
input terminal and earth ground.
Do not contact the test lead tips or any uninsulated portion of the accessory.•
Using this unit near equipment that generates electromagnetic interference can result in •
unstable or inaccurate readings.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
Do not operate with the case or battery compartment open.•
Before opening the case or battery compartment, remove the test leads from the circuit and •
shut off the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
Do not attempt to repair this unit. It contains no user-serviceable parts.•
Do not expose the unit to extremes in temperature or high humidity. Refer to •
“Specifications.”
Failure to observe these precautions may result in injury and can damage the unit.
To Next Page
Loading...
Need help?
General
