7
Installation Cont:
7. Plug the power adapter into the DC adapter plug-in on the left side of your pureWash
and then plug the adapter into a wall outlet.
8. Ensure all hoses are properly installed and tightened, and that the power supply has
been properly installed. SLOWLY turn the water supply back on and check for any
leaks or drips. Gently tighten ttings if leaks are apparent, but DO NOT overtighten.
CAUTION: e hot water hose should not be disconnected form the washer. You
can turn o the hot water or leave it on, but the hose must be installed to the washing
machine to prevent backow of water out of the washing machine during use.
Indicators and Alarms:
Indicator Light
• e indicator light, viewed through the window on the front of your pureWash has two
states of operation.
• A blue light indicates the normal operation of the pureWash.
• A ashing red light indicates the fan or oxidizer generator is not operating properly. Please
contact your distributor for service.
Alarm
• Your pureWash unit is equipped with an internal leak detector. If a leak happens to
develop inside the unit, water will accumulate on the bottom panel. e sensor will set
o an audible alarm and continue to sound until the leak is stopped and/or the unit is
unplugged. If this alarm should occur, you should unplug the unit, turn o the cold
water valve and call your distributor for assistance.
To Next Page
Loading...