GreenWorks Tools G40LT User Manual (English)

Questions and Answers:

T
Thomas ChavezAug 5, 2025
What to do if my GreenWorks Tools G40LT Trimmer motor fails to start when the switch trigger is depressed?
- J
  Joseph CooperAug 5, 2025
  If the motor fails to start when you depress the switch trigger, there are several potential causes. First, ensure the battery is secure by checking that the latch on the bottom of the battery pack snaps into place. Second, verify that the battery is charged according to the instructions included with your model. Lastly, make sure the lower shaft is fully seated in the shaft coupler on the upper shaft and that the shaft coupler is secure.
A
Autumn FaulknerAug 14, 2025
Why won't the string advance on my GreenWorks Tools G40LT bump-feed head?
- W
  wnelsonAug 14, 2025
  If the string won't advance on your bump-feed head, it could be due to several reasons. The string might be welded to itself, in which case you should lubricate it with silicone spray. Alternatively, there might not be enough string on the spool, so you should install more, referring to the string replacement section in the manual. It's also possible the string is worn too short, requiring you to pull the string while pressing the line release button. Finally, the string could be tangled on the spool, necessitating its removal and rewinding, again referring to the string replacement section.
T
Tracy QuinnAug 25, 2025
How to prevent grass from wrapping around the shaft housing and string head of my GreenWorks Tools Trimmer?
- K
  Kimberly VazquezAug 25, 2025
  To prevent grass from wrapping around the shaft housing and string head, avoid cutting tall grass at ground level. Instead, cut tall grass from the top down.