GreenWorks BVA808 - Operation Tips; 11 Maintenance; Clean the Machine; Clean the Collection Bag

4. Keep the collected unwanted materials in front of
you.
NOTE
Use rakes and brooms to loosen the unwanted
material before you blow.
NOTE
Use the low speed to move dry items, and high speed
to move heavy items such as large unwanted
materials or gravel.
10.6 OPERATION TIPS
• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
11 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Disconnect the plug from the power source before
maintenance.
11.1 CLEAN THE MACHINE
CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
11.2 CLEAN THE COLLECTION BAG
• Wear safety glasses and a dust mask.
• If it is necessary, clean the bag 1 time a year or
more.
1. Remove the bag.
2. Turn the bag inside out.
3. Hang the bag up and clean it.
4. Hang the bag to dry.
5. Turn the bag right-side out and install it again.
11.3 CLEAN A BLOCKED TUBE /
IMPELLER
1. Wait until the machine fully stops.
2. Remove from the power source.
3. Remove the blower tube or mulcher tubes and the
bag.
4. Remove the material that causes a blockage of the
tube or impeller.
5. Make sure that the impeller has no damage.
6. Turn the impeller with the hand to make sure that
there is no blockage.
7. Install the blower tube or mulcher tubes and the
bag.
WARNING
Avoid the intake of large objects that could damage
the impeller.
11.4 EXAMINE EXTENSION CABLES
• Look carefully for deterioration, cuts or cracks in the
insulation.
• Examine the plug for damage.
• Replace cables if defective or damaged.
12 TRANSPORTATION AND
STORAGE
WARNING
Disconnect the plug from the power source before
tranportation and storage.
12.1 MOVE THE MACHINE
• Only hold the machine with the handgrip.
12.2 STORE THE MACHINE
• Clean the machine before storage.
9
English
EN