GreenWorks BVF441 - Assemble as a Mulcher; Assemble as a Blower

10.2 ASSEMBLE AS A MULCHER
WARNING
Make sure that the machine is in the OFF position, and the
impellers stop before you attach or remove tubes.
1. Move the front and rear mulcher tubes together until the
lock button engages.
2. Pull the lock button (10) forward to disengage the gate.
ķ
10
3. Hold the gate open.
4. Put the "wedged" end clip of the mulcher tube into the
rear clip.
ĸ
5. Push the "hooked" end clip of the mulcher tube into the
front clip.
Ĺ
6. Push back the lock button to engage the mulcher tubes.
ĺ
Ļ
TIP
You can do the steps above in the opposite sequence to
remove the mulcher tubes.
7. Put the bag adaptor into the blower outlet. Lock the bag
adaptor with the lock button.
NOTE
It can be necessary to remove the blower tube or mulcher
tubes to clean a blocked tube or impeller.
10.3 ASSEMBLE AS A BLOWER
1. Move the blower tube (4) forward until the notched area
(11) clicks into the slot (12).
2. Put the concentrator nozzle (5) into the blower tube to
lock.
PUSH
INSERT
PUSH
OUT
12
4
5
11
NOTE
You can use the concentrator nozzle to increase airflow
in tight areas: flower beds, under decks, etc.
7
English
EN