What to do if the GreenWorks ST40L02 line keeps breaking?
If the line on your GreenWorks Trimmer keeps breaking, it might be due to incorrect usage. Try cutting with the tip of the line, and avoid contact with stones, walls, and other hard objects. Also, regularly advance the cutting line to maintain a full cutting width.
What to do if grass winds around the GreenWorks ST40L02 head?
If grass is winding around the trimmer head and motor housing of your GreenWorks Trimmer, it's likely because you're cutting tall grass at ground level. Cut tall grass from the top down, removing no more than 8 inches in each pass to prevent wrapping.
Why won't my GreenWorks ST40L02 Trimmer start?
If your GreenWorks Trimmer doesn't start, several issues might be the cause. First, there may be a poor electrical connection between the battery and the machine. Try removing the battery, checking the contact points, and reinstalling it. Second, the battery pack might be depleted, so you should charge it. Finally, ensure you are simultaneously pressing the lock-out button and the trigger. Pull and hold the lock-out button, then pull the trigger to start the trimmer.
What causes high vibration in GreenWorks ST40L02?
If you notice a significant increase in vibration in your GreenWorks Trimmer, it could be because the line is worn down on one side and hasn't been advanced in time. Check that the line on both sides is normal and advance the line as needed.
Why GreenWorks ST40L02 doesn't start?
If your GreenWorks Trimmer doesn't start when you push the trigger, it could be due to a few reasons. First, ensure there's good electrical contact between the battery pack and the machine by removing and reinstalling the battery pack. Secondly, the battery pack may be depleted and needs charging. Lastly, make sure you are simultaneously pulling the lock-out button and the trigger to start the machine.
How to fix GreenWorks Trimmer line that won't advance?
If the line on your GreenWorks Trimmer isn't advancing, there are a few potential reasons. The lines might be welded together, in which case you should lubricate them with silicone spray. Alternatively, there might not be enough line on the spool, so install more line. If the lines are worn too short, try advancing the cutting line. Finally, the lines could be tangled on the spool; remove them and wind them neatly.
Why does the GreenWorks ST40L02 Trimmer line keep breaking?
If the line on your GreenWorks Trimmer keeps breaking, it's likely due to incorrect usage. To prevent this, cut with the tip of the line and avoid stones, walls, and other hard objects. Also, regularly advance the cutting line to maintain a full cutting width.
How to prevent grass from winding around my GreenWorks ST40L02 head?
If grass is winding around the trimmer head and motor housing of your GreenWorks Trimmer, it's likely because you're cutting tall grass at ground level. To avoid this, cut tall grass from the top down, removing no more than 8" in each pass to prevent wrapping.
What to do if GreenWorks ST40L02 line does not cut well?
If the line on your GreenWorks Trimmer isn't cutting well, the cut-off blade may have become dull. Sharpen the cut-off blade with a file or replace it.
Why does my GreenWorks Trimmer vibrate so much?
If the vibration of your GreenWorks Trimmer increases noticeably, it could be because the line is worn down on one side and hasn't been advanced in time. Ensure the line on both sides is normal and advance the line.
General| Type | String Trimmer |
|---|---|
| Power Source | Battery |
| Voltage | 40V |
| Runtime | Up to 60 minutes |
| Line Feed | Automatic |
| Battery Type | Lithium-Ion |
| Battery Included | Yes |
| Charger Included | Yes |
| Line Diameter | 0.065 inches |
| Cutting Width | 13-in |
To Next Page